Friedrich PDH07K3SG Manual de instalación

Busca en linea o descarga Manual de instalación para No Friedrich PDH07K3SG. Friedrich PDH07K3SG Friedrich PTAC Sleeve Extension Retrofit Kit Installation Instructions [de] Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
VERIFY KIT CONTENTS
Before starting installation, make sure that the following
parts are included:
• One sheet metal wall sleeve adapter.
• Two long and two short pieces of styrofoam insulation
with adhesive backing.
• Two long and two short adhesive-backed gasket pieces.
• Two Tinnerman's Clips.
• Ten #10 screws.
920-127-01 (1-05)
Installation Instructions
WALL SLEEVE ADAPTER KIT
For Use With Packaged Terminal Units
Please read these instructions completely before attempting installation.
NOTE: This kit retrofi ts the earlier shallow "T" series Friedrich wall sleeve to accommodate more modern, deeper
"PD" series PTAC units. Refer to Chassis Installation/Operation Manual for additional information.
Model PXSE
WARNING
Electrical shock hazard.
Electrical power MUST be disconnected.
Failure to disconnect power can result in
property damage, personal injury and/or death.
STEP 1: WALL SLEEVE ADAPTER ORIENTATION
The wall sleeve adapter increases the depth of existing wall sleeves to accept deeper PTAC units. The adapter
mounts to the front of the existing sleeve inside of the room. The sleeve should be oriented so that the Stickout
Flange is inside the existing sleeve and the Fold-over Flange is positioned to the bottom front of the adapter
as shown in illustration.
Fold-over
Flange
Room
Existing Wall
Sleeve
Wall
Sleeve
Adapter
Stickout
Flange
STEP 2
Insert the stickout flange of the wall sleeve adapter over the bottom flange of the existing sleeve.
Make sure that the top of the sleeve is level with the top surface of the adapter.
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - Installation Instructions

VERIFY KIT CONTENTSBefore starting installation, make sure that the following parts are included:• One sheet metal wall sleeve adapter.• Two long and

Pagina 2

2STEP 4Install two Tinnerman's clips over the holes on the top flange of the wall sleeve. The flat round hole on the Tinnerman's clips shou

Pagina 3

3STEP 6Fasten the adapter to the wall sleeve with six ½" long #10 screws. All screws are driven from the inside of the adapter into the Tinnerm

Pagina 4 - Printed in the U.S.A

920-127-01 (1-05)FRIEDRICH AIR CONDITIONING CO. INC.Post Office Box 1540 · San Antonio, Texas 78295-15404200 N. Pan Am Expressway · San Antonio, Texas

Comentarios a estos manuales

Sin comentarios