Friedrich RC 11 Manual de usuario

Enviromaster International LLC5780 Success Dr.Rome, NY 13440www.retroaire.comINSTALLATION, OPERATION AND MAINTENANCE MANUALAn ISO 9001-2000 Certified C

10www.retroaire.comThe Right Fit For ComfortHydronic Only: Remove the 2-position connector as-sembly from kit bag supplied with unit (this will have 2

11www.retroaire.comThe Right Fit For ComfortRC21 REPLACEMENT PTACINSTALLATION INSTRUCTIONS1. Take unit out of packaging. 2. Slide unit into wall

12www.retroaire.comThe Right Fit For Comfort6. 1” x 1” Open cell foam strips are provided to prevent outside air from entering around the chassis to

13www.retroaire.comThe Right Fit For Comfort*Refer to the charts on page 23 for electrical and optional electric heat specifications.1. Take unit out o

14www.retroaire.comThe Right Fit For ComfortRC/RH45 REPLACEMENT PTAC INSTALLATION INSTRUCTIONS1. Take unit out of packaging. 2. Slide unit into wall s

15www.retroaire.comThe Right Fit For ComfortFront ViewCooling ChassisWall Sleeve1x1 Foam TapeRC/RH45 PERFORMANCE DATA*Unit SizeCooling BtuhEERsHeat

16www.retroaire.comThe Right Fit For ComfortRC/RH80 REPLACEMENT PTACINSTALLATION INSTRUCTIONSAir Filter 8”x30” Permanent Aluminum Mesh1. Take unit out

17www.retroaire.comThe Right Fit For ComfortRC/RH80 INSTALLATION INSTRUCTIONS (Continued)RC/RH80 Performance Date*UNIT SIZECOOLING BTUHEERHEAT PUMP BT

18www.retroaire.comThe Right Fit For ComfortIMPORTANT: The RC/RH90 chassis is 18 1/4” deep for the 9,000, 12,000, and 15,000 Btuh models. The stand

19www.retroaire.comThe Right Fit For ComfortRC/RH90 FINAL INSPECTION AND START-UP( All other units see “Final Inspecton and Startup” page 20)1. Mount

2www.retroaire.comThe Right Fit For ComfortINSTALLATION, OPERATION, AND MAINTENANCE MANUALP/N# 240004146, Rev. 1.7 [02/07]This manual is intended

20www.retroaire.comThe Right Fit For Comfort1. Make sure the chassis is level. Check by pouring water into the drain pan and making certain it flows th

21www.retroaire.comThe Right Fit For Comfortcontrols will power a normally closed valve that is the same voltage as the unit (ex: a unit rated

22www.retroaire.comThe Right Fit For ComfortSEQUENCE OF OPERATION (CONTINUED)CHOOSING A THERMOSTAT: EMI offers a thermostat that is compatible wi

23www.retroaire.comThe Right Fit For ComfortHP HPSEQUENCE OF OPERATION (CONTINUED)condition be detected, the compressor and condenser fan will be swit

24www.retroaire.comThe Right Fit For Comfort11. Replace panels and reconnect electrical power.12. Test unit operation.CLEANING THE EXTERIOR 1. Clean t

25www.retroaire.comThe Right Fit For Comfort Due to EMI’s ongoing development programs, design, specifications, and performance data may change without

26www.retroaire.comThe Right Fit For ComfortALL PRODUCT LIMITED WARRANTYEnviromaster International LLC (EMI) warrants to the purchaser/owner that EMI

3www.retroaire.comThe Right Fit For ComfortINSTALLER RESPONSIBILITIESThis manual has been prepared to acquaint you with the installation, operation an

4www.retroaire.comThe Right Fit For ComfortThe RetroAire Dual Motor PTAC is available in nominal sizes of 9,000 Btuh, 12,000 Btuh, 15,000 Btuh

5www.retroaire.comThe Right Fit For ComfortPREPARATION FOR INSTALLATIONIMPORTANT: RetroAire Dual Motor PTACs are to be used with metal wallsleeves.

6www.retroaire.comThe Right Fit For ComfortEVAP BLOCK OFFInstall 1/2” x 1/2” Foam Tape1. Take unit out of packaging. 2. Slide unit into wall sleeve. I

7www.retroaire.comThe Right Fit For ComfortRC11 PERFORMANCE DATA*UNIT SIZE COOLING BTUH EER FRESH AIR CFM9 9500 10 40/3512 11,900 10 40/3515 14,700 9.

8www.retroaire.comThe Right Fit For ComfortINSTALLATION INSTRUCTIONS1. Take unit out of packaging. 2. Slide unit into wall sleeve. The supply duct on

9www.retroaire.comThe Right Fit For ComfortAIR INTAKE FILTER5 1/2”8 1/2”35 15/16”4”3”2”REMOVEABLE WEATHER SEAL ANGLES22” CONDENSER COIL14 13/16”A18 1/